Start up Power Draw

From 45 Drives Technical Information Wiki
Jump to: navigation, search

See the following links for more detailed power analysis:

Power Analysis Part 1 (Consumer Drives)
Power Analysis Part 2 (Effects of Staggered Spin Up)
Power Analysis Part 3 (Enterprise Drives)

Startup Power Draw

The following graphs are of the current draw and the power draw of 15 hard drives loaded into the Storinator. We chose to measure 15 drives as that was a good base line for showing the startup surges for the 30, 45, and 60 unit Storinator, just multiply the numbers in the plots below by 2 for the 30 pod, 3 for the 45 pod and 4 for the 60 pod.

It is important to note that the drives we chose to measure were our "worst case scenario" drives. These are Enterprise level drives (1 TB Seagate Constellation ES.3) that suck alot of power

To measure the DC power consumption of the HDDs a clamp current meter was used to measure both the 5V line and the 12V line. The output of the current clamp was fed into a amplification and filtering circuit which was then obsevered on a oscilloscope.


Startup powerdraw 15HDD.JPG

DC Power Draw 15 HDDs (Total 5V & 12V lines)

Here is a 10 second capture of total DC power draw (Watts) for 15 HDDs (ST10000NM0033). You can see that the initial 4 seconds are the most taxing on the PSU, however quickly settles into steady state operation after about 6.5 seconds.

Note that this plot is for 15 very power hungry enterprise HDDs, most consumer drives are not this demanding.

However it is clear that for a very short time HDDs pull a lot of power! scale this up for a full XL60 and you can have startup draws up to 1600W.

This is when enabling staggered spin up (SSU) on your drives comes in, you can reduce the maximum power peak significantly. Please see this page on more detail on how SSU works in our machines and how to turn it on.Staggered Spin Up






















Startup curretn draw 15HDD.JPG

DC Current Draw 15 HDDs (5V line & 12V line)

Here is the current draw on startup for both the 12V line (yellow) and the 5V line (red).

It is clear the 12V line dominates the power draw on start up. This large spike is due the large inrush currents caused by the electric motors in the drives used to get the disks spinning. Therefore you can expect HDDs with more platters than others will have high start-up draws. After about 6.5 seconds the 12V current line falls to its steady state level and stays constant while the computer runs.

The 5V line during startup is not as exciting as the 12V line as it doesn't require as much power to startup the logic circuits as spinning up the platters. However once the drives are spun up and the OS boots the 5V line gets interesting. The 5V line is powering all the circuits in the HDD and as you read/write to the disk we can see some fluctuation in the current draw.

The next plot is the current draw on the 5V line under various read/write conditions.

Reads pull the most current with random being more demanding than sequential, writes require less current however a sequential write is more demanding than a random write.

5V HDD supply line under various disk operations